RL V6-3.5L (2007)
Checking and Adjusting the Headliner/Pillar Trim Overlap
To prevent the side curtain airbag from deploying and damaging the pillar trim, the overlap between the headliner and pillar trim must be less then 15
mm. To check the overlap, do this:
1. Install the headliner (A) and the pillar trim (B).
2. Using masking tape on the headliner, mark the upper edge of each pillar trim.
3. Remove the pillar trim, and measure the headliner overlap.
-
If the overlap is less than 15 mm, remove the tape, and install the pillar trim.
-
If the overlap is more than 15 mm, go to step 4.