RL V6-3.5L (2007)
14. Check for continuity between the slip rings (A).
-
If there is continuity, go to step 15.
-
If there is no continuity, replace the rotor assembly.
15. Check for continuity between each slip ring and the rotor (B) and the rotor shaft (C).
-
If there is no continuity, replace the rear housing assembly, and go to step 16.
-
If there is continuity, replace the rotor assembly.
16. Assemble the alternator in the reverse order of disassembly, and note these items:
-
Be careful not to get any grease or oil on the slip rings.
-
If you removed the pulley, tighten its locknut to 110 N.m (11.2 kgf.m, 81.0 lbf.ft) when you reinstall it.