RL V6-3.5L (2007)
3. Place a 29.4 mm (1.16 in.) outside diameter plastic pipe on the armature.
4. Move the brush holder (A) up to the pipe (B) while holding the pipe so the brushes do not pop out from the holder.
Armature Inspection and Test
5. Disassemble the starter as shown at the beginning of this procedure.
6. Inspect the armature for wear or damage from contact with the permanent magnet. If there is wear or damage, replace the armature.
7. Check the commutator (A) surface. If the surface is dirty or burnt, resurface with emery cloth or a lathe within the following specifications, or
recondition with #500 or #600 sandpaper (B)
