RL V6-3.5L (2007)
20. Remove the dirt and oil from the sealing surface. Apply liquid gasket (P/N 08718-0001) to the sealing surface. Make sure you seal the entire
circumference of the bolt holes to prevent oil leakage.
NOTE:
-
You must assemble the housings with you do in 5 minutes after applying the liquid gasket. If not, the sealing surface must be cleaned, and the
liquid gasket reapplied.
-
Allow it to cure at least 30 minutes after assembly before filling the differential with fluid.
21. Install the two 8 x 14 mm dowel pins (A) and the 8 x 130 mm pipe (B).
22. Align the hole (C) of the front case (D) with the 8 x 130 mm pipe. Align the groove (E) of the front case with the high clutch tabs (F), then install
the front case onto the center case.
23. Set the companion flange (A) onto the front case (B) by aligning the reference mark (C), then install the 36 mm socket (D), the 8 mm flange bolt
(E), and the 8 mm nut (F) as shown.