RL V6-3.5L (2007)
14. Remove the spring clip/washer (B) and the control pin (C), then separate the shift cable end (D) from the control lever (E). Check synthetic resin
bushing (F) in the shift cable end for a proper fit and wear. If the bushing is fitted loose or worn, replace the shift cable.
15. Disconnect the connectors from the A/T clutch pressure control solenoid valve A, B, solenoid harness, transmission range switch, ATF
temperature sensor, output shaft (countershaft) speed sensor, input shaft (mainshaft) speed sensor, 3rd clutch transmission fluid pressure switch,
and 4th clutch transmission fluid pressure switch.
16. Remove the bolt securing the harness cover (A).
17. Remove the A/T clutch pressure control solenoid valves A and B, ATF pipes (C), gasket (D), and O-rings (E).
