RL V6-3.7L (2009)
5. Disconnect the front fog light connectors (A), outside temperature sensor connector (B), and the headlight washer tube (C), then remove the front
bumper (D).
6. Release the hooks, then remove the front bumper absorber (A).
7. Install the bumper in the reverse order of removal, and note these items:
-
Make sure the front fog light connectors and the outside temperature sensor connector are plugged in properly, and the headlight washer tube
is connected properly.
-
Make sure the front bumper engages the hooks (of both corner upper beams and side spacers) on each side securely.
-
If the clips are damaged or stress-whitened, replace them with new ones.
-
Push the clips and hooks into place securely.