RL V6-3.7L (2009)
Rear Door Panel: Service and Repair
Rear Door Panel Removal/Installation
Rear Door Panel Removal/Installation
Special Tools Required
-
KTC trim tool set SOJATP2014*
-
Trim pad remover, Snap-on A 177A or equivalent, commercially available
*Available through the Acura Tool and Equipment Program.
NOTE: Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
1. Using a trim tool, push on the bottom hook (A) and pivot the cover (B) on the upper hook (C), then detach the front hook (D), and then remove the
cover and the screws securing the inner handle (E).
2. Using a trim tool, pull up the rubber mat (A), then remove the screw.
3. Release the clips that hold the door panel (A) with a commercially available trim pad remover (B).