RL V6-3.7L (2009)
4. Remove the door panel (A) with as little bending as possible to avoid creasing or breaking it.
-1 While holding the door panel, pull the panel upward to release it from the upper clips (B, C).
While holding the door panel away from the door, disconnect the door subharness connector (D) and the power window switch connector (E).
-3 While holding the door panel away from the door, remove the screws (F), then remove the inner handle (G) from the door panel.
NOTE: The inner handle cable (H) and the lock cable (I) are connected to the door panel. Do not pull the door panel up too far, or the inner handle cable
will be damaged.
5. Remove the remaining clips from the door.
-1 Using a clip remover, remove the clips (A).
Put on gloves to protect your hands. Using a knife, cut the boss (B) of the clip (C).
-3 Push the clip, and then pull it away.
6. Replace all of the door panel clips with new ones.
