RL V6-3.7L (2009)
Rear Door Panel: Service and Repair
Rear Door Sash Inner Trim Replacement
Rear Door Sash Inner Trim Replacement
Special Tools Required
-
KTC trim tool set SOJATP2014*
*Available through the Acura Tool and Equipment Program.
NOTE:
-
Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
-
Take care not to scratch the door.
1. Remove the door panel. See: Front Door/Front Door Weatherstrip/Service and Repair/Front Door Weatherstrip Replacement
2. Using a trim tool, pry the caps (A), and remove the screws, then remove the rear side sunshade hooks (B).
3. Using a clip remover, detach the clips fastening the front door sash inner trim (A).
4. Pull the door glass opening side of the trim back to release the hooks (B) from the door glass opening flange of the door sash.
5. Install the trim in the reverse order of removal, and note these items:
-
If the clips are damaged or stress-whitened, replace them with new ones.
-
Push the hooks and clips into place securely.