RL V6-3.7L (2009)
Trim Panel: Service and Repair
Interior Trim Removal/Installation - B-Pillar Lower Trim
Interior Trim Removal/Installation - B-Pillar Lower Trim
Special Tools Required
-
KTC trim tool set SOJATP2014*
*Available through the Acura Tool and Equipment Program.
B-Pillar Lower Trim
SRS components are located in this area. Review the SRS component locations See: Restraint Systems/Air Bag Systems/Locations and the precautions
and procedures See: Dashboard / Instrument Panel/Air Bag(s) Arming and Disarming/Service and Repair before doing repairs or service.
NOTE:
-
Put on gloves to protect your hands.
-
Take care not to bend or scratch the trim and the panels.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
1. Remove these items:
-
Front door sill trim See: Scuff Plate/Service and Repair/Interior Trim Removal/Installation - Front Door Sill Area
-
Rear door sill trim See: Scuff Plate/Service and Repair/Interior Trim Removal/Installation - Rear Door Sill Area
-
Front door opening trim, as needed See: Scuff Plate/Service and Repair/Interior Trim Removal/Installation - Front Door Sill Area
-
Rear door opening trim, as needed See: Scuff Plate/Service and Repair/Interior Trim Removal/Installation - Rear Door Sill Area
2. Slide the front seat forward fully.
3. Remove the B-pillar lower trim (A).
-1 Pull the upper portion of the trim back to release the upper hooks (B).
-2 Detach the lower clips by pulling the bottom of the trim back by hand.
4. Install the trim in the reverse order of removal, and note these items: