RL V6-3.7L (2009)
8. Slide the cable assembly (A) and both glass brackets (B) back, remove the deflector sliders (C) from both glass brackets, then remove them from
the frame (D).
9. Install the slider and the cable assembly in the reverse order of removal, and note these items:
-
Damaged parts should be replaced.
-
Apply molybdenum grease to the glass bracket (A) and the guide rail portion of the frame (B) indicated by the arrows.
-
Before reinstalling the motor, make sure both link lifters are parallel, and in the fully closed position.
-
Before reinstalling the motor, slide both drain channel sliders (C) rearward fully until the slider portions of the inner cable contact the slide
stops (D) on the guide rail to slide both drain channel sliders.
-
Before reinstalling the motor, install the frame and the glass, then check the opening drag. See: Testing and Inspection/Component Tests and
General Diagnostics/Moonroof Closing Force and Opening Drag Check
-
After reinstalling the motor, reset the moonroof control unit. See: Testing and Inspection/Programming and Relearning
