RL V6-3.7L (2009)
10. Install the frame and the drain tube in the reverse order of removal, and note these items:
-
Before installing the frame, clear the drain tubes and the drain valves using compressed air.
-
When installing, tie the string that was left in the pillar to the top end of a new drain tube and pull it up into the roof.
-
Check the frame seal.
-
Clean the surface of the frame.
-
When installing the frame, first attach the rear hooks into the body holes.
-
Make sure the connectors are plugged in properly.
-
When connecting the drain tubes, slide them over the frame nozzles at least 10 mm (0.39 in.).
-
Install the tube clips (A) on the drain tubes (B) as shown.
-
After all parts are installed, including the headliner, reset the moonroof control unit. See: Testing and Inspection/Programming and Relearning
-
Do the glass position adjustment. See: Adjustments
11. Check for water leaks. Let the water run freely from a hose without a nozzle. Do not use a high-pressure spray.