RL V6-3.7L (2009)
14. Remove airbag wire B from the outside reinforcing cloths (C). Remove airbag wire A and the inside reinforcing cloths (D), then remove the wires.
15. Install the cover in the reverse order of removal, and note these items:
-
Reinitialize the ODS unit. See: Restraint Systems/Air Bag Systems/Testing and Inspection/Programming and Relearning/ODS Unit
Initialization
-
To prevent wrinkles when installing a seat-back cover, make sure the material is stretched evenly over the pad before securing the clips, the
hooks, and the hook strips.
-
Before installing the seat-back cover, make sure airbag wires (A, B) are installed to the reinforcing cloths (C) correctly, and wires A and B are
securely assembled.
-
Replace any upholstery rings you removed with new ones (D). Install them with commercially available upholstery ring pliers (E).
-
Use only original Honda replacement seat-back covers.
-
Make sure the seat-back heater harness, and OPDS sensor harness (passenger's seat) are routed properly.
-
Replace the back cover clips with new ones.