RL V6-3.7L (2009)
11. Tighten each bolt two turns at a time in the sequence shown to ensure that the rockers do not bind on the valves.
12. Install the injector base (A). Always use a new gasket (B).
13. Apply new engine oil to the threads of the camshaft pulley mounting bolt (A). Install the back cover (B), then install the camshaft pulley (C).
14. Set the camshaft pulleys to top dead center (TDC) before bolting them onto the engine block. See: Cylinder Head Assembly/Service and
Repair/Removal and Replacement/Cylinder Head Installation
