RL V6-3.7L (2009)
Rear
1. Loosen the valve adjusting screws.
2. Apply a light coat of new engine oil around the camshaft oil seal.
3. Gently tap the new camshaft oil seal (A) into the cylinder head.
-1 Tap the camshaft oil seal in squarely.
-2 Install the oil seal about 0.5-1.5 mm (0.02-0.06 in.) below the surface of the cylinder head.
4. Insert the camshaft (B) into the cylinder head, then install the camshaft thrust cover (C). Always use a new O-ring (D). Apply new engine oil to the
camshaft journals and lobes.
5. Check that the oil seal lips are not distorted.
6. Install the hollow dowel pin (E).
7. If the rocker arm assembly is disassembled, reassemble the rocker arm assembly. See: Cylinder Head Assembly/Service and
Repair/Overhaul/Rocker Arm and Shaft Disassembly/Reassembly
8. Remove all of the old liquid gasket from the rocker shaft holder and the cylinder head.
9. Apply liquid gasket (P/N 08717-0004, 08718-0001, 08718-0003, or 08718-0009) to the rocker shaft holder mating surface of the cylinder head.
Install the component within 5 minutes of applying the liquid gasket.
NOTE:
-
Apply liquid gasket about 2.5 mm (0.098 in.) diameter bead along the broken line (A).
-
If you apply liquid gasket P/N 08718-0012, the component must be installed within 4 minutes.
