RL V6-3.7L (2009)
8. Remove the sealing bolts from the front cylinder head, then install the VTEC/VCM air adapter (A) to the inspection hole and install the VTEC air
stop tool B, then connect the air pressure regulator (C).
9. Remove the sealing bolts from the rear cylinder head, then install the VTEC air stop tool A to the inspection hole and install the VTEC/VCM air
adapter (B), then connect the air pressure regulator (C).
10. Loosen the valve on the regulator, and apply the specified air pressure.
Specified Air Pressure:
550-690 kPa (5.6-7.0 kgf/cm2, 80-100 psi)
11. With the specified air pressure applied, rotate the crankshaft pulley clockwise, and visually check all intake primary rocker arms (A) and intake
secondary rocker arms (B) move together.
-
If the intake primary rocker arm and the intake secondary rocker arm move independently, remove the intake primary rocker arm and the
intake secondary rocker arm as an assembly, and check that the pistons in the rocker arms move smoothly. If any intake rocker arm needs
replacing, replace the primary and secondary rocker arms as an assembly, then retest.
-
If the intake primary rocker arm and the intake secondary rocker arm move together, go to step 12.
