RL V6-3.7L (2009)
Relay Box: Service and Repair
Driver's Under-Dash Fuse/Relay Box (MICU) Removal/Installation
Driver's Under-dash Fuse/Relay Box (MICU) Removal/Installation
Special Tools Required
-
Relay puller 07AAC-000A1A0
SRS components are located in this area Review the SRS component locations. See: Restraint Systems/Air Bag Systems/Locations and precautions and
procedures See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Air Bag(s) Arming and Disarming/Service and Repair before
performing repairs or servicing.
Removal
1. Do the battery terminal disconnection procedure. See: Starting and Charging/Battery/Service and Repair/Procedures
2. Remove the left front door sill trim and left kick panel. See: Body and Frame/Interior Moulding / Trim/Scuff Plate/Service and Repair/Interior
Trim Removal/Installation - Front Door Sill Area
3. Disconnect the connectors from the fuse side of the driver's under-dash fuse/relay box (A).
NOTE: If necessary, remove the parking brake pedal assembly to make a space.
4. Remove the mounting bolt, release the tab (B) and pull the driver's under-dash fuse/relay box away from the body.
5. Disconnect the connectors and remove the driver's under-dash fuse/relay box.
6. Carefully remove the relays using the relay puller.
NOTE: Do not use pliers. Pliers will damage the relays, which could cause the engine to stall or not start.
Installation
1. Install the relays and connect the connectors to the driver's under-dash fuse/relay box, then install the driver's under-dash fuse/relay box in the
reverse order of removal.
2. Install the removed parts in the reverse order of removal.
3. Do the battery terminal reconnection procedure. See: Starting and Charging/Battery/Service and Repair/Procedures
4. Confirm that all systems work properly.
