RL V6-3.7L (2009)
-
Store the SRS unit, front impact sensors, rear safing sensor, and side impact sensors in a cool (less than 104 °F/40 °C) and dry (less than 80 %
relative humidity, no moisture) area.
Wiring Precautions
Some of the SRS wiring can be identified by special yellow outer covering, and the SRS connectors can be identified by their yellow color. Observe the
following instructions.
-
Never attempt to modify, splice, or repair SRS wiring.
If there is an open or damage in SRS wiring or terminals, replace the harness.
-
Be sure to install the harness wires so they do not get pinched or interfere with other parts.
-
Make sure all SRS ground locations are clean and grounds are securely fastened for optimum metal-to-metal contact. Poor grounds can cause
intermittent problems that are difficult to diagnose.
-
Do not use any silicone based cleaners or lubricants on any SRS connectors or terminals.
Precautions for Electrical Inspections
-
When using electrical test equipment, insert the probe of the tester into the wire side of the connector. Do not insert the probe of the tester into the
terminal side of the connector, and do not tamper with the connector.
-
Use back probe adapter 07TAZ-001020A.
