RL V6-3.7L (2009)
To remove the retainer (A), insert a flat-tip screwdriver (B) between the connector body and the retainer, then carefully pry out the retainer. Take care
not to break the connector.
Seats with Side Airbags
Seats with side airbags have a "SIDE AIRBAG" label on the seat-back.
-
When cleaning, use a damp cloth to clean the seat. Do not soak the seat with liquid. Do not spray steam on the seat.
-
Do not repair a torn or frayed seat-back cover; replace it.
-
After a collision where the side airbag was deployed, replace the seat-back cover and side airbag with new parts. If the seat-back cushion is split, it
must be replaced. If the seat-back frame is deformed, it must be replaced.
-
Never put aftermarket accessories on the seat (covers, pads, seat heaters, lights, etc.).
Disconnecting System Connectors
Turn the ignition switch to LOCK (0), disconnect the negative cable from the battery, then wait for 3 minutes before starting the following procedures.
-
Before disconnecting the cable reel 4P connector (1), disconnect the driver's airbag 4P connector (2).
-
Before disconnecting SRS unit connector B from the SRS unit, disconnect both seat belt tensioner 4P connectors (3, 4).
