RL V6-3.7L (2009)
Air Bag: Removal and Replacement
Driver's Airbag Replacement
Driver's Airbag Replacement
Removal
1. Do the battery terminal disconnection procedure, See: Starting and Charging/Battery/Service and Repair/Procedures then wait at least 3 minutes
before starting work.
2. Remove the access panel (A) from the steering wheel, then disconnect the driver's airbag 4P connector (B) from the cable reel.
3. Using a TORX T30 bit, remove the two TORX bolts (A).
4. Disconnect the horn switch connector (1P), then remove the driver's airbag (B).
Installation
1. Place the new driver's airbag (A) in the steering wheel, connect the horn switch connector (1P), then secure it with new TORX bolts (B).