RL V6-3.7L (2009)
Air Bag Control Module: Service and Repair
SRS Unit Replacement
SRS Unit Replacement
Removal
NOTE: If you are only disconnecting SRS unit connector A, skip step 2.
1. Do the battery terminal disconnection procedure, See: Starting and Charging/Battery/Service and Repair/Procedures then wait at least 3 minutes
before starting work.
2. Disconnect both seat belt tensioner connectors. See: Air Bag Systems/Air Bag(s) Arming and Disarming/Service and Repair
3. Remove the center trim. See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Dashboard Center
Trim Removal/Installation
4. Remove the center console. See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Removal and Replacement/Center
Console Removal/Installation
5. Remove the rear vent duct. See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Dashboard/Steering
Hanger Beam Removal/Installation
6. Disconnect SRS unit connector A (28P), SRS unit connector B (28P), SRS unit connector C (28P), and remove the TORX bolts (D), then pull out
the SRS unit.
Installation
1. Install the new SRS unit (A) with the TORX bolts (B), then connect the connectors (C) to the SRS unit; push them into position until they click.
NOTE: Be sure the SRS unit is sitting squarely against its bracket before torquing the TORX bolts.
2. Reconnect both seat belt tensioner connectors. See: Air Bag Systems/Air Bag(s) Arming and Disarming/Service and Repair
3. Do the battery terminal reconnection procedure. See: Starting and Charging/Battery/Service and Repair/Procedures
4. Calibrate the ODS unit. See: Air Bag Systems/Testing and Inspection/Programming and Relearning/ODS Unit Calibration
5. Do the front ODS unit operation check. See: Air Bag Systems/Testing and Inspection/Component Tests and General Diagnostics/ODS Unit
Operation Check
6. After installing the SRS unit, confirm proper system operation: Turn the ignition switch to ON (II); the SRS indicator should come on for about 6
seconds and then go off.
7. Reinstall all removed parts.