RL V6-3.7L (2009)
-
When removing or installing the side curtain airbag inflator assembly, never handle the flexible bag (B) or the adapter pipe (C).
SRS Unit, Front and Side Impact Sensors, Driver's Seat Position Sensor, ODS unit, Front Passenger's Weight Sensors, and Rear Safing Sensor
-
Turn the ignition switch to LOCK (0), disconnect the negative cable from the battery, and wait at least 3 minutes before beginning installation or
replacement of the SRS unit or disconnecting the connectors from the SRS unit.
-
Be careful not to bump or impact the SRS unit, front impact sensors, rear safing sensor, or side impact sensors when the ignition switch is ON (II),
or for at least 3 minutes after the ignition switch is turned OFF.
-
During installation or replacement, be careful not to bump (by impact wrench, hammer, etc.) the area around the SRS unit, front impact sensors,
rear safing sensor, or side impact sensors. The airbags could accidentally deploy and cause damage or injury.
-
After a collision where a front airbag, a side airbag, a side curtain airbag, or a seat belt tensioner deployed, go to Component
Replacement/Inspection after Deployment. See: Air Bag Systems/Service and Repair After a collision where the airbags or the side airbags did
not deploy, inspect for any damage or any deformation on the SRS unit, front impact sensors, rear safing sensor, and side impact sensors. If there
is any damage, replace the SRS unit and/or the sensors.
-
Do not disassemble the SRS unit, front impact sensors, side impact sensors, driver's seat position sensor, ODS unit, rear safing sensor, and front
passenger's weight sensors.
-
Be sure the SRS unit, front impact sensors, rear safing sensor, and side impact sensors are installed securely with the mounting bolts torqued to 9.8
N-m (1.0 kgf-m, 7.2 lbf-ft).
-
Do not spill water or oil on the SRS unit or the side impact sensors, and keep them away from dust.
