RL V6-3.7L (2009)
Seat Belt Tensioner: Removal and Replacement
E-pretensioner Unit Replacement
NOTE:
-
Do not turn the ignition switch to ON (II) while the e-pretensioner unit connectors are disconnected.
-
Do not remove the parking brake cable from the parking brake pedal.
1. Remove the accelerator pedal module. See: Powertrain Management/Fuel Delivery and Air Induction/Accelerator Pedal/Service and Repair
2. Disconnect the connectors (A) from the e-pretensioner unit (B).
3. Remove the e-pretensioner unit from behind the heater unit.
4. Install the unit in the reverse order of removal.
5. After installing the e-pretensioner unit, make sure the SRS indicator comes on for about 6 seconds after turning the ignition switch to ON (II), then
goes off.
