RL V6-3.7L (2009)
Impact Sensor: Service and Repair
Front Impact Sensor Replacement
Front Impact Sensor Replacement
Removal
1. Do the battery terminal disconnection procedure, See: Starting and Charging/Battery/Service and Repair/Procedures then wait at least 3 minutes
before starting work.
2. Disconnect the driver's airbag 4P connector See: Air Bag Systems/Air Bag(s) Arming and Disarming/Service and Repair, the front passenger's
airbag 4P connector See: Air Bag Systems/Air Bag(s) Arming and Disarming/Service and Repair, and both seat belt tensioner 2P connectors See:
Air Bag Systems/Air Bag(s) Arming and Disarming/Service and Repair.
3. Remove the front bumper. See: Body and Frame/Bumper/Front Bumper/Service and Repair/Front Bumper Removal/Installation
4. Disconnect the engine compartment wire harness 2P connector (A), and using a TORX T30 bit, remove the two TORX bolts (B), then remove the
front impact sensor (C).
Installation
1. Install the new front impact sensor with new TORX bolts (A), then connect the engine compartment wire harness 2P connector (B) to the front
impact sensor (C).
2. Reconnect the driver's airbag 4P connector, See: Air Bag Systems/Air Bag(s) Arming and Disarming/Service and Repair the front passenger's
airbag 4P connector, See: Air Bag Systems/Air Bag(s) Arming and Disarming/Service and Repair and both seat belt tensioner 4P connectors.
See: Air Bag Systems/Air Bag(s) Arming and Disarming/Service and Repair
3. Do the battery terminal reconnection procedure. See: Starting and Charging/Battery/Service and Repair/Procedures
4. After installing the front impact sensor, confirm proper system operation: Turn the ignition switch to ON (II); the SRS indicator should come on
for about 6 seconds and then go off.
5. Reinstall all removed parts.