RL V6-3.7L (2009)
Safing Sensor: Service and Repair
Rear Safing Sensor Replacement
Removal
1. Do the battery terminal disconnection procedure, See: Starting and Charging/Battery/Service and Repair/Procedures then wait at least 3 minutes
before starting work.
2. Remove the rear seat. See: Body and Frame/Seats/Service and Repair/Rear Seat Removal/Installation
3. Disconnect the left side wire harness 2P connector from the rear safing sensor.
4. Using a TORX T30 bit, remove the TORX bolts (A), then remove the rear safing sensor (B).
Installation
1. Install the new rear safing sensor (A) with the TORX bolts (B) then connect the left side wire harness 2P connector (C) to the rear safing sensor.
2. Do the battery terminal reconnection procedure. See: Starting and Charging/Battery/Service and Repair/Procedures
3. After installing the rear safing sensor, confirm proper system operation: Turn the ignition switch to ON (II); the SRS indicator should come on for
about 6 seconds and then go off.
4. Reinstall all removed parts.
