RL V6-3.7L (2009)
14. Turn the ignition switch to LOCK (0).
15. Disconnect the PSP switch 2P connector.
16. Connect PSP switch 2P connector terminals No. 1 and No. 2 with a jumper wire, then turn the ignition switch to ON (II).
17. Check the PSP SWITCH in the DATA LIST with the HDS.
Does it change to ON?
YES - Replace the PSP switch.
NO - Go to step 18.
18. Turn the ignition switch to LOCK (0).
19. Remove the jumper wire from the PSP switch 2P connector.
20. Jump the SCS line with the HDS.
21. Disconnect PCM connector E (31P).
22. Connect PSP switch 2P connector terminal No. 1 to body ground with a jumper wire.
23. Check for continuity between body ground and PCM connector terminal E17.
Is there continuity?
YES - Go to step 24.
