RL V6-3.7L (2009)
5. Check the commutator diameter. If the diameter is below the service limit, replace the armature.
6. Measure the commutator (A) runout.
-
If the commutator runout is within the service limit, check the commutator for carbon dust or brass chips between the segments.
-
If the commutator runout is not within the service limit, replace the armature.
7. Check the mica depth (A). If the mica is too high (B), undercut the mica with a hacksaw blade to the proper depth. Cut away all the mica (C)
between the commutator segments. The undercut should not be too shallow, too narrow, or V-shaped (D).
