RL V6-3.7L (2009)
Power Steering Pump: Overhaul
Power Steering Pump Overhaul
Exploded View
Disassembly
NOTE: Refer to the Exploded View as needed during the following procedure.
1. Drain the fluid from the pump.
2. Remove the power steering pump. See: Removal and Replacement
3. Remove the inlet joint and the O-ring.
4. Loosen the flow control valve cap with a hex wrench, and remove it and the O-ring, the flow control valve, and the spring.
5. Remove the pump cover and the pump cover seal.
6. Remove the snap ring, then remove the outer side plate, the cam ring, the rotor, the vanes, the side plate, and the O-rings.
7. Remove the snap ring, then remove the pump driveshaft by tapping the shaft end with a plastic hammer.
8. Remove the seal from the pump housing.
