RL V6-3.7L (2009)
2. Slide the outboard boot (A) partially to the inboard joint side. Be careful not to damage the boot.
3. Wipe off the grease to expose the driveshaft and the outboard joint inner race.
4. Make a mark (A) on the driveshaft (B) at the same level as the outboard joint end (C).
5. Securely clamp the driveshaft in a bench vise with a shop towel.
6. Remove the outboard joint (A) using a 26 x 1.5 mm threaded adapter (B) and a commercially available 5/8'' x 18 UNF slide hammer (C).
7. Remove the driveshaft from the bench vise.
8. Remove the stop ring from the driveshaft.
