RL V6-3.7L (2009)
17. Unwind the boot band tool, and cut off the excess free end of the band to leave a 5-10 mm (0.2-0.4 in.) tail protruding from the clip.
18. Bend the band end (A) by tapping it down with a hammer.
NOTE:
-
Make sure the band and the clip do not interfere with anything on the vehicle, and the band does not move.
-
Clean any grease remaining on the surrounding surfaces.
19. Repeat step 11 through 18 for the band on the other end of the boot.
20. Install the new low profile band (A) onto the boot (B), then hook the tab (C) of the band.