RL V6-3.7L (2009)
21. Close the hook portion of the band with commercially available boot band pliers (A), then hook the tabs (B) of the band.
22. Install the boot band on the other end of the boot, and repeat step 20 and step 21.
Outboard Joint Side
1. Wrap the splines with vinyl tape (A) to prevent damaging the outboard boot.
2. Install the new ear clamp bands (B) and the outboard boot, then remove the vinyl tape. Be careful not to damage the outboard boot.
3. Install a new stop ring (A) onto the driveshaft groove (B).
