RL V6-3.7L (2009)
Axle Shaft Assembly: Removal and Replacement
Front Driveshaft Installation
Front Driveshaft Installation
NOTE: Before starting installation, make sure the mating surfaces of the joint and the splined section are clean.
1. Apply about 5 g (0.18 oz) moly 60 paste (P/N 08734-0001) to the contact area (A) of the outboard joint and front wheel bearing.
NOTE: The paste helps prevent noise and vibration.
2. Install a new set ring (A) onto the set ring groove (B) of the left driveshaft inboard joint.
3. Install a new set ring (A) onto the set ring groove (B) of the intermediate shaft.
4. Apply 0.5-1.0 g (0.02-0.04 oz) of super high tempurea grease (P/N 08798-9002) to the whole splined surface (A) of the right driveshaft. After
applying grease, remove the grease from the splined grooves at intervals of 2-3 splines and from the set ring groove (B) so that air can bleed from
the intermediate shaft.
5. Clean the areas where the driveshaft contacts the differential thoroughly with solvent or brake cleaner, and dry with compressed air.
NOTE: Do not wash the rubber parts with solvent.