RL V6-3.7L (2009)
6. Insert the inboard end (A) of the driveshaft into the differential (B) or intermediate shaft (C) until the set ring (D) locks in the groove (E).
NOTE: Insert the driveshaft horizontally to prevent damaging the oil seal.
7. Install the outboard joint (A) into the front hub (B) on the knuckle.
8. Install exhaust pipe A. See: Engine, Cooling and Exhaust/Exhaust System/Exhaust Pipe/Service and Repair
9. Install the knuckle holder to the knuckle, and then tighten a new knuckle holder bolt (A) and a new nut (B).
10. Install the damper fork (A) over the driveshaft and onto the lower arm. Install the damper in the damper fork so the aligning tab (B) is aligned with
the slot in the damper fork. Loosely install the damper pinch bolt (C).