RL V6-3.7L (2009)
11. Loosely install a new flange bolt (D) and a new damper fork mounting nut (E).
12. Connect the front stabilizer link (A) to the lower arm and loosely install a new flange nut. Hold the stabilizer link ball joint pin (B) with a hex
wrench (C), and tighten the new flange nut (D).
13. Place a floor jack under the lower arm, and raise the suspension to load it with the vehicle's weight.
NOTE: Do not put the floor jack under the ball joint.
14. Tighten the damper pinch bolt and the damper fork mounting nut while holding the flange bolt to the specified torque values, then remove the floor
jack.
15. Apply a small amount of engine oil to the seating surface of the new spindle nut (A).
16. Install the spindle nut, then tighten it. After tightening, use a drift to stake the spindle nut shoulder (B) against the driveshaft.
17. Clean the mating surfaces of the brake discs and the wheels, then install the front wheels.
18. Turn the front wheel by hand, and make sure there is no interference between the driveshaft and the surrounding parts.
19. Lower the vehicle on the lift.
20. Refill the transmission with recommended transmission fluid. See: Automatic Transmission/Transaxle/Service and Repair/Removal and
Replacement/ATF Replacement
21. Check the wheel alignment, and adjust it if necessary. See: Maintenance/Alignment/Service and Repair
22. Test-drive the vehicle.