RL V6-3.7L (2009)
12. Attach the upper rubber dam (A), the lower rubber dam (B), the clips (C), and the fasteners (D) with adhesive tape to the inside face of the rear
window (E) as shown:
-
Before installing the upper rubber dam, apply primer to the upper corner areas where it adhesive tape will be stuck in inside face of the rear
window.
-
Be sure the lower rubber dam, the clips, and the fasteners line up with the alignment marks (F).
-
Be sure the convex portion (G) of the left and the right clips face toward the left.
-
Be careful not to touch the windshield where adhesive will be applied.
13. Attach the lower molding (A) with adhesive tape (B) to the lower edge of the rear window (C):
-
After installing the molding, cut the ends (D) of the molding as shown.