acura Workshop Repair Guides

Acura (Honda) Workshop Service and Repair Manuals

All Technical Service Bulletins for Trunk / Liftgate Latch:|00-017|Page 11151 > < Customer Interest for Trunk / Liftgate Latch:|00-017|Page 11148
Page 1
background image

Trunk / Liftgate Latch: All Technical Service Bulletins
Body - Trunk Lid Does Not Close Properly

June 5, 2000

BULLETIN NO.
00-017

Applies To:
1996-99 3.5RL - ALL
2000 3.5RL - From VIN JH4KA9. . .YCOOOOO1 thru JH4KA9. . .YC009805

Trunk Lid Does Not Close Properly

SYMPTOM

The trunk lid is difficult to close or it will not close.

PROBABLE CAUSE

The striker is bent.

CORRECTIVE ACTION

Replace the striker.

PARTS INFORMATION

Trunk Striker Assembly: P/N 74862-S82-AO1

WARRANTY CLAIM INFORMATION

In warranty: The normal warranty applies.

Out of warranty: Any repair performed after warranty expiration may be eligible for goodwill consideration by the District Parts and Service Manager or
your Zone Office. You must request consideration, and get a decision, before starting work.

DIAGNOSIS

Hit the striker with a dead blow hammer towards the rear of the vehicle (one or two hits should be sufficient). Check the operation of the trunk lid.

If the trunk lid does not close properly, disregard this bulletin, and look for other possible causes.

If the trunk lid closes properly, go to REPAIR PROCEDURE.

REPAIR PROCEDURE

1.

Remove the rear trim panel (see page 20-43 of the 1996-00 3.5RL Service Manual).

All Technical Service Bulletins for Trunk / Liftgate Latch:|00-017|Page 11151 > < Customer Interest for Trunk / Liftgate Latch:|00-017|Page 11148