RL V6-3474cc 3.5L (1998)
NOTE: Keep the lamp 40-50 cm (16-20 in) from the filler while drying.
-
Stop drying the filler if a white mark appears when the surface is scratched with your nail. Wet or dry sand the surface flat and smooth with a
#280 or #320 paper.
6. Air Blowing/Degreasing
-
Air blow the surface to be repaired, then degrease with a wax and grease remover (for USA usage- DuPont 38125 Enamel Reducer).
-
Use the following materials:
-
Spies Hecker Silicon Remover (Herberts)
-
Standox silicon Remover (Herberts)
NOTE: Also clean and degrease surfaces where masking tape will be attached.
7. Masking
Mask the areas surrounding the damage to prevent overspray from the primer.
8. Application and Drying of Primer/Drying
WARNING:
-
Ventilate when spraying paint. Most paint contains substances that are harmful if inhaled or swallowed. Read the paint label before
opening the paint container.
-
Avoid contact with skin. Wear an approved respirator, gloves, eye protection and appropriate clothing when painting.
-
Paint is flammable. Store it in a safe place, and keep it away from sparks, flames or cigarettes.
-
Spray the primer over the filler and surface (use epoxy or urethane 2-part primer).
Spray : 2-3 coats.
-
Use the following materials:
-
615S Primer Surfacer (DuPont)
-
Primer Surfacer EP (Akzo)
-
NPS735 Urethane Primer Surfacer (R-M)
-
Spies Hecker Permacron HS Surfacer (Herberts)
-
Standox 2K HS Filler (Herberts)
-
Let the primer air dry for 5-10 minutes, then force dry with a infrared lamp.
NOTE: Keep the dryer 40-50 cm (16-20 in) from the surface.
9. Polishing Undercoat
-
Remove the masking paper and tape.
-
Check that the undercoat has dried thoroughly, then dry or wet sand the surface with a #280 or #320 paper.
NOTE:
-
Use a rubber block and sand flat and smooth.
-
Sand the entire surface to be refinished.
10. Air Blowing/Degreasing
WARNING:
-Do not use high air pressure; use only an approved, 210 kPa (2.1 kgf/sq.cm, 30 psi) air nozzle.
-Wear goggles or safety glasses to prevent eye injury.
-
Air blow all the surfaces, then degrease with wax and grease remover (for USA usage-DuPont 38125 Enamel Reducer).
-
Use the following materials:
-
Spies Hecker Silicon Remover (Herberts)
-
Standox silicon Remover (Herberts)
NOTE: Also degrease the surfaces where masking tape will be attached.
11. Masking
Mask the undamaged areas surrounding the damage to prevent overspray from primer surfacer (undercoat).
NOTE: Use masking tape and paper to mask the body. A vinyl cover may also be used to effectively mask the body.
12. Application of Intermediate Coat 1/Drying
