RL V6-3474cc 3.5L (1998)
WARNING:
-
Ventilate when spraying paint. Most paint contains substances that are harmful if inhaled or swallowed. Read the paint label before
opening paint container.
-
Avoid contact with skin. Wear an approved respirator, gloves, eye protection and appropriate clothing when painting.
-
Paint is flammable. Store in a safe place, and keep it away from sparks, flames or cigarettes.
-
Spray either 2-part epoxy or urethane primer surfacer to the polished primed surface as an intermediate coat.
-
Let the paint coat air dry for 5-10 minutes, then force dry with an infrared lamp.
NOTE: Keep the dryer 40-50 cm (16-20 in) from the surface.
For replacement parts:
Spray intermediate coat 2 over the surface.
NOTE:
-
For inner surfaces, you may start with Step 16 "Application of Intermediate Coat 2"
-
Top coat enamel is used for this purpose
13. Polishing of Intermediate Coat 1
Check that the undercoat is dried thoroughly, then dry or wet sand the surface with a #400 or #600 paper.
NOTE: Use a rubber block and sand flat and smooth, covering entire surface.
14. Air Blowing/Degreasing
WARNING:
-
Do not use high air pressure; use only an approved, 210 kPa (2.1 kgf/sq.cm, 30 psi) air nozzle.
-
Wear goggles or safety glasses to prevent eye injury.
-
Air blow the entire surface, then degrease with a wax and grease remover (for USA usage-DuPont 38125 Enamel Reducer).
-
Use the following materials:
-
Spies Hecker Silicon Remover (Herberts)
-
Standox silicon Remover (Herberts)
15. Masking
Check the masking paper (Step 11) for tears or fouling, and repair or reinforce as necessary.
16. Application of Intermediate Coat 2
WARNING:
-
Ventilate when spraying paint. Most paint contains substances that are harmful if inhaled or swallowed. Read the paint label before
opening paint container.
-
Avoid contact with skin. Wear an approved respirator, gloves, eye protection and appropriate clothing when painting.
-
Paint is flammable. Store in a safe place, and keep it away from sparks, flames or cigarettes.
-
Use the same color paint as the top coat, and spray it over the surface until the intermediate coat (primer surfacer) is fully covered.
-
Spray the paint slightly thicker than normal to allow for loss during subsequent polishing.
-
Super ponacle II (R-M)
-
Super Centari (Du Pont)
-
Auto cryl (Akzo) -Spies Hecker Permacron 2K Acrylic Top Coat (Herberts)
-
Standocryl 2K (standox) (Herberts)
17. Polishing of Intermediate Coat 2
-
Check that the paint coat has been dried thoroughly, then dry or wet sand the surface with a #600, #800, or #1000 paper.
NOTE: Use a rubber block and sand flat and smooth, being careful not to expose the intermediate coat 1.
Polishing of Top Coat (if damaged):
-
Use the same technique described above.
18. Air Blowing/Degreasing
WARNING:
-
Do not use high air pressure; use only an approved, 210kPa (2.1 kgf/sq.cm, 30 psi) air nozzle.
-
Wear goggles or safety glasses to prevent eye injury.
