RSX L4-2.0L (2005)
Front Door Panel: Service and Repair
Door Panel Removal/Installation
Special Tools Required
-
Trim pad remover. Snap-on A 177Aor equivalent, commercially available
-
KTC trim tool set SOJATP2014
NOTE: Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
1. Remove the inner handle (A). Take care not to scratch the door panel.
1. Pry out on the bottom portion of the cover (B) to release the clip (C) and tabs (D), then remove the cover.
2. Remove the screws.
3. Pull the inner handle out to release the hook (E).
4. Pull the inner handle forward and out half-way to release the hook (F).
5. Disconnect the inner handle cable (G) and power door lock switch connector (H).
2. Lower the glass fully.
3. Remove the screws from the armrest portion and inner handle opening.