RSX L4-2.0L (2005)
Note these items during reassembly:
-
Before installing the covers, apply Multitemp SA grease or equivalent to the pivot (E) on the latch lever.
-
Make sure the AFT seal (F) of the inner handle cable is installed in the covers securely.
7. If necessary, disconnect the inner handle cable (A) from the latch (B) and bushing (C).
For 06 model: Replace the AFT seal (D) if necessary.
8. Install the latch in the reverse order of removal, and note these items:
-
Make sure the actuator connectors are plugged in properly, and each rod and cable are connected securely.
-
Make sure the door locks and opens properly.
-
When reinstalling the door panel, make sure the plastic cover is installed properly and sealed around its perimeter.
-
For 06 model: Peel off the old AFT seal on the covers if necessary. Clean the surface and the edges of the covers with alcohol where new
adhesive is to be applied. Attach the new AFT seals (A) to the edges and surface of the covers as shown.
