RSX L4-2.0L (2005)
Front Door Latch: Service and Repair
Door Latch Replacement
NOTE: Put on gloves to protect your hands.
1. Raise the glass fully.
2. Remove these items:
-
Door panel
-
Plastic cover, as necessary
-
Rear lower channel
-
Lock rod protector, 02-05 models
3. Disconnect the cylinder rod from the lock cylinder, and disconnect the outer handle rod from the outer handle.
4. Release the inner handle cable (A) from the inner handle bracket (B), and using a clip remover, detach the cable clips (C) from the door.
5. Disconnect the actuator connectors (A), and remove the screws, then remove the latch (B) through the hole in the door. Take care not to bend the
outer handle rod (C), cylinder rod (D), lock rod (E), and inner handle cable (F).
6. For 06 model: Remove the screws, then remove the upper cover (A). Remove the base cover (B) by release the hook (C) and pulling it from the
latch (D).