RSX L4-2.0L (2005)
Seat Cover: Service and Repair
Front Seat Cover
Front Seat Cover Replacement
Special Tools Required
KTC trim tool set SOJATP2014
SRS components are located in this area. Review the SRS component locations and the precautions and procedures before performing repairs or service.
NOTE:
-
Take care not to tear the seams or damage the seat covers.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when paying components.
-
On the passenger's seat with side airbag, do not touch the OPDS sensor in the seat-back pad, and keep it away from oil. Oil can corrode the sensor,
causing it to fail.
-
Put on gloves to protect your hands.
Seat-back Cover
1. Remove the front seat.
2. From under the seat cushion, detach the side airbag connector clip (A), and on the passenger's seat, detach the OPDS unit connector clip (B).
Release the seat cushion cover (C) from the seat cushion frame spring (D), then pull the cover back, and remove the harness bands (E). The
passenger's seat is shown, the driver's seat is symmetrical except it has no OPDS unit connector.
3. Fold the seat-back forward.
4. If equipped with a lumbar support, remove the clip (A), then remove the lumbar support handle (B).