RSX L4-2.0L (2005)
Connecting Rod Bearing: Specifications
Connecting Rod Bearing Selection
Rod Bearing Selection
1. Inspect each connecting rod for cracks and heat damage.
Connecting Rod Big End Bore Code Locations
2. Each rod has a tolerance range from 0 to 0.024 mm (0.0009 inch), in 0.006 mm (0.0002 inch) increments, depending on the size of its big end
bore. It's then stamped with a number or bar (1, 2, 3 or 4/I, II, III, or IIII) indicating the range. You may find any combination of numbers and bars
in any engine, (Half the number or bar is stamped on the bearing cap, the other half on the rod).
If you can't read the code because of an accumulation of oil and varnish, do not scrub it with a wire brush or scraper. Clean it only with solvent or
detergent.
Connecting Rod Journal Code Location
