RSX L4-2.0L (2005)
Crankshaft: Service and Repair
Crankshaft Inspection
Crankshaft Inspection
Out-of-Round and Taper
1. Remove the crankshaft from the engine block.
2. Clean the crankshaft oil passages with pipe cleaners or a suitable brush.
3. Clean the keyway and threads.
4. Measure out-of-round et the middle of each rod and main journal in two places. The difference between measurements on each journal must not be
more than the service limit.
5. Measure taper at the edges of each rod and main journal. The difference between measurements on each journal must not be more than the service
limit.
Journal Taper
Standard (New): 0.005 mm (0.0002 inch) max.
Service Limit: 0.010 mm (0.0004 inch)
Straightness
6. Place the engine block on the surface plate.
7. Clean and install the bearings on the No. 1 and No. 5 journal of the engine block.
8. Lower the crankshaft into the block.
