RSX L4-2.0L (2005)
9. Move the engine (not the bracket) in the directions of the arrows to center the bolt and nut in the oversized bolt holes of the side engine mounting
bracket. Torque the bolt and the nut to 54 N.m (40 lb-ft).
NOTE:
Two people may be needed, one to move the engine, and the other to observe the alignment and tighten the fasteners.
10. With the jack still under the engine, place a pry bar against the transmission mounting bracket, and move the bracket in the direction of the arrow
until the oversized hole is covered by the centered bolt and nut, then torque the bolt to 54 N.m (40 lb-ft).
