RSX L4-2.0L (2005)
Information Bus: Diagnostic Trouble Code Tests and Associated Procedures
Mode 2 Test
Mode 2 Test
1. From mode 1, disconnect the special tool from the multiplex inspection connector for 5 to 10 seconds, and then reconnect it.
2. The ignition key light and ceiling light should come on for 2 seconds, go out, then blink twice, 0.2 seconds each time. The system is now in Mode
2.
3. Operate the switches listed above: If the circuit is OK, the ignition key light and ceiling light will blink once. If the circuit is faulty, the lights will
not blink.
Tip: Operating the switches most closely related to the problem you are diagnosing is a quick way of testing the circuits integrity.
4. If all inputs were confirmed, or multiple circuits failed at the same time in Mode 2, go to the Multiplex Sleep Mode Test. If a single switch fails in
Mode 2, troubleshoot its circuit.
