RSX L4-2.0L (2005)
Seat Belt: Service and Repair
Front Seat Belt
Front Seat Belt Replacement
SRS components are located in this area. Review the SRS component locations and the precautions and procedures before performing repairs or service.
NOTE: Check the front seat belts for damage, and replace them if necessary
Front Seat Belt
1. Make sure you have the anti-theft code for the radio, and then write down the frequencies for the preset buttons.
2. Disconnect the negative cable from the battery, and wait at least 3 minutes before beginning work.
3. Slide the front seat forward fully.
4. Remove the rear side trim panel.
5. Remove the lower anchor cap (A), and remove the lower anchor bolt (B)
6. Remove the upper anchor cap (A), and remove the upper anchor bolt (B).