RSX L4-2.0L (2005)
3. Remove the four through bolts.
4. Heat the rear bearing seat with a 1,000 W hair drier for about 5 minutes (129 - 140 °F, 50 - 60 °C).
5. Separate the rear housing from the drive-end housing by inserting a flat tip screwdriver into the openings and prying them apart.
NOTE: Be careful not to damage the stator with the tip of the screwdriver.
6. Separate the rear housing (A) and drive-end housing (B) with the stator (C) attached to the rear housing.