RSX L4-2.0L (2005)
2. Remove the cotter pin (A) from the tie-rod end ball joint, and remove the nut (B).
3. Disconnect the tie-rod end from the steering arm on the damper using the special tools.
4. Remove the bolts, and remove the wheel sensor harness bracket (A) and brake hose bracket (B) from the damper. Do not disconnect the wheel
sensor connector.
5. Remove the damper pinch bolts (A) while holding the nuts (B).
6. Remove the flange nuts (A) from the top of the damper.
7. Lower the lower arm, then remove the damper assembly (B).
Disassembly/Inspection