RSX L4-2.0L (2005)
Shift Cable: Adjustments
Shift Cable Adjustment
1. Remove the center console.
2. Shift the transmission into N position.
3. Remove the nut securing the shift cable end, then separate the cable end from the shift lever.
4. Rotate the socket holder (A) on the shift cable (B) a quarter turn; the tab (C) on the socket holder will be in the opening of the shift lever bracket
base (D). Then slide the holder to remove the shift cable from the shift lever bracket base (D). Do not remove the shift cable by twisting the shift
cable guide (E).
5. Push the shift cable (A) until it stops, then release it. Pull the shift cable back two steps so that the shift position is in N. Do not push and pull the
shift cable by holding the shift cable guide (B).
6. Turn the ignition switch ON (II), and verify that the N position indicator comes on.
7. Turn the ignition switch OFF.